Description
NOTE: 1.Make sure your section of LED light strip is 10MM wide 4 PIN NON-WATERPROOF RGB LED Strip.
2 .Need to peel off the silicone on the surface of led light strip when you want to connect WATERPROOF LED strip.
3. Ensure your Wire Diameter 20-18AWG and without stripping wire .
Firmly bite through led light strip, don’t like traditional connector only conductive connection
Updated version of LED strip connector, assemble wire by yourself as needed, flexible to different project! Both solderless for rgb led strip and wire joint. Just clasp your prepared led strip section into the connector to get connected. worry-free solution for non-waterproof 5050 4pin LED light strip connection and extension needs,extension for whatever the wire length you want to connect. compatible with 30-120 LEDs/M strip, made of flame retardant material, safely use. Support high current LED strip lights.
Solderless Wire Joint Quick Splice Connector for 20-18awg Cable
Our products were an innovative safe and quick wire connector,peeling free,tapping free and twisting free. well waterproof and dust proof function. it greatly changes the way of wire connection .it allow any users to just insert the wire into wire joint and press cover by pliers to connect the wire safely and conveniently.
Installation Instructions:
Strip End:
1.Open the transparent cover of connector up to 90 degrees.
2 .Insert led strip section to the END of led strip connector, put the contact point of led strip on the PINS of the connector.
3. Close the transparent cap with a plier
Wire End :
1.Cut the desired wire length and insert it directly into the guide slot.
2.Make sure that the positive & negative on the led strip light surface are corresponding to the ones on the wires.
3.Close the transparent cap with a plier.
4. End of installation.
